Download a 30-Day free trial

HomeDocumentationConfigurationSMTP Monitor

2.11. SMTP Monitor

SMTP monitor dialog.

The SMTP monitor connects to a SMTP server, sends an e-mail, and then disconnects. 

Send E-Mail To:  The e-mail address to send the monitoring message to.
Send E-Mail From: The e-mail address that goes monitoring should appear to come from.
Use SMTP Authentication:  Check this box if the SMTP server requires a username and password.
SMTP Username:  The SMTP username to use.
SMTP Password:  The  SMTP password to use.
Use Secure SMTP:  Check this box to connect to the SMTP server using SSL.  The server must be running in SSL mode.
Server Port:  The port the monitor should connect to.  The default SMTP port is 25.  Valid port numbers are 1 to 65535.
Retries:  If the monitor fails, this number of times the monitor will attempt to reconnect before notifying you of the failure.  The retry attempts occur at one minute intervals, regardless of the interval setting.  The monitor will report the failure immediately in the Retries value is set to zero.
Interval:  This is the number of minutes between the monitor queries.  It must be between 1 and 1440 (one day).
Timeout:  This is the number of milliseconds before the monitor query is considered a failure.
Monitor Enabled:  Check this box to enable the monitor.

This page was: Helpful | Not Helpful